The average person is not going to give their water purifier a second thought as long as the water being produced tastes normal. Generally speaking, you turn on your water purifier, wait for it to produce water, fill up your bottle and go about your day. However, what do you do when the water produced starts tasting a little different?

 

 You or someone else in your household may start noticing a strange aftertaste. Or you start smelling a strange odor coming from the water and the rest of the family starts thinking you’ve lost it.

 

These minor changes can absolutely drive you up the wall and make you wonder if your purifier is functioning correctly.

 

If you are looking for water purifier ro service in rewa, know that there can be several reasons for a change in taste, and often it is a combination of factors.

 

Take for example, the filters

 

Both the pre and post RO membrane filters can be the reason for taste change. Also, with time and usage, the RO membrane itself can be compromised. Additionally, in certain models, there can be filters dedicated to influence the final taste of water produced.

 

Finally, the makeup of the water being purified can also vary, and so the conditions being imposed on the purifier can also vary.

 

Then we have the storage tank. Water that has been left unused for some time may not necessarily taste the same as fresh water. In such cases, it is best to abide by the manufacturer’s directions before using the purifier again.

 

So, don’t assume that every time there is a change in taste, the membrane needs to be replaced. We need to find the root cause for the same.

 

When to Arrange Water Purifier RO Service

 

Sometimes, a slight change in taste may not necessarily indicate that there is a major fault. However, there are a few situations which require our attention and action.

 

Some of these include:-

 

- Water begins to taste or smell unusual.

 

- Water purifier takes too long to purify water.

 

- Water flow from the purifier outlet reduces.

 

- Unusual sounds from the purifier.

 

- There are signs of leakages.

 

- Purifier has not been serviced in a long time.

 

If you suspect that the purifier has developed a fault, it is best not to use the water for drinking or cooking until the purifier is tested to ensure the safety of the water. We should not depend on taste or smell to test whether water is safe.

 

When arranging water purifier RO service, explain in detail what has changed and when you first noticed it. Even minor details like the change happening after the supplier of the water has been changed, can also be helpful in the diagnosis.

 

 Avoid Fixing Taste Issues Yourself

 

It's human nature to look things up online, and if there's a problem with your TDS controller, for example, you might think the solution is as simple as watching a quick video and replacing the filter. In some cases, people will even go as far as ordering a filter online because they think that must be the issue.

 

I would recommend against doing any of that if you don't have the knowledge to do so safely.

 

There are a lot of electrical connections, piping, and other components that, if not put together properly, can lead to leakage and other issues with your RO purifier. There are different filter models and if you use a replacement part that is not for the model you have, it can cause more problems.

 

There are a few things you can check without opening the unit.

 

-Make sure the outside of the unit is clean

 

-Check for leakage around the unit

 

-Watch to see if the tank takes longer to fill

 

-Check the power connection for damage

 

-See when the unit was last serviced

 

There are things inside the unit that should be replaced or cleaned on a routine basis, and those should be left to a professional. If you're not sure how to do something safely, ask a technician.

 

People usually remember the filter but not the water tank. That's understandable because usually the tank is enclosed inside the unit.

 

The tank can and should be cleaned and sanitized. If you're not sure the best way to do that, you should consult the owner's manual or contact the manufacturer.

 

There are flushing procedures for purifiers that are often long since they haven't been used in a while. Before drinking water from it, consult your owner's manual to see if there are any special flushing procedures for your purifier.

 

There are a couple of things left to mention. Don't put household cleaning liquids in the purifier tank, unless otherwise recommended by the manufacturer. A product that may be suited for kitchen surfaces may not be for a drinking water system.

 

 Keep track of the service dates, don’t guess.

 

There are a couple reasons for this habit. You may need to remember what was replaced at each service. You may need to refer to the service record to remind yourself of what else was done during the service. Keep a service record along with the bill if provided.

 

Imagine you notice an issue a few months after service. Instead of taking a guess as to when the filter was replaced, you can look at your service record and give the technician that information.

 

Always refer to the manufacturer to see what they recommend for the life of the filter or membrane, and when it should be replaced.

 

Questions to ask:

 

1. What could be the reason for the change in taste and/or smell in the water?

 

2. Have the relevant filters and membranes been checked?

 

3. Does the storage tank need to be cleaned according to the instructions given by the manufacturer?

 

4. What components actually need to be replaced?

 

5. What will the inspection and repair cost?

 

6. Is there a warranty on the replacement parts and/or the service?

 

It is absolutely justified to ask for a price quote before agreeing to a replacement. Make sure that the replacement parts are approved for your brand and model of purifier.

 

In case you are considering OnDoorService, check the local service availability, charges, and service terms and conditions before confirming a service request.

 

The quality of water should be regularly tested to ensure the safety of drinking water. A purifier should be the last line of defense for treating water for drinking.

 

If your source water supply is suspect, have it tested to cross-check if the treatment your purifier is doing is adequate. For families with small children and/or senior citizens, it’s always prudent to use an alternative safe water source until the water quality is confirmed to be safe.

 

FAQs

1. My RO water suddenly started tasting strange, what could be the reason?

 

The reason could be due to change in source water quality, condition of the filters and membranes or contamination of the storage tank. An inspection will help identify the reason.

 

2. Can water tasting different from before always mean that the RO membrane is damaged?

 

Not necessarily. Different things can affect the taste of water. Replacing the membrane in such a situation may not be needed.

 

3. Should I use RO water if it smells bad?

 

It is better not to use the water until the issue is resolved. The water may not be safe to drink even if it has an unpleasant smell.

 

4. How often should RO filters be replaced?

 

It varies based on the model of the purifier, quality of water and how much it is used. The filters should be changed based on the recommendations of the manufacturer. If the performance of the purifier is not good, it may be time for service.

 

5. How do I find the RO service in Rewa?

 

Search for local services. One option is OnDoorService. Check for the availability of the technician, cost for inspection and service terms before booking.

 

FINAL THOUGHTS

 

Changes in the taste of water may seem minor, but it should not be ignored. Don't take a guess as to which part has failed or continue to drink water you suspect may not be safe.

 

Log changes, keep your service records and follow the recommendations for maintenance by the manufacturer. If the purifier needs service, consider getting the "ro maintenance service in rewa."